Brocade Fabric OS Encryption Administrator’s Guide Supporting HP Secure Key Manager (SKM) and HP Enterprise Secure Key Manager (ESKM) Environments (Supporting Fabric OS v7.2.0) - Manual (Page 71)

Fabric OS Encryption Administrator’s Guide (SKM/ESKM) 51
53-1002923-01
Adding a switch to an encryption group
2
7. Back up the master key to a file. (Opaque key vaults only). Brocade Network Advisor saves the
master key in the specified file.
Adding a switch to an encryption group
The setup wizard allows you to either create a new encryption group, or add an encryption switch to
an existing encryption group. Use the following procedure to add a switch to an encryption group:
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box. (Refer to Figure 1 on page 14.)
2. Select a switch to add from the Encryption Center Devices table, then select Switch >
Create/Add to Group from the menu task bar.
NOTE
The switch must not already be in an encryption group.
The Configure Switch Encryption wizard welcome screen displays. (Refer to Figure 25 .)
FIGURE 25 Configure Switch Encryption wizard - welcome screen
3. Click Next.
The Designate Switch Membership dialog box displays. (Refer to Figure 26 .)