Brocade Fabric OS Encryption Administrator’s Guide Supporting HP Secure Key Manager (SKM) and HP Enterprise Secure Key Manager (ESKM) Environments (Supporting Fabric OS v7.2.0) User Manual
Page 185
Fabric OS Encryption Administrator’s Guide (SKM/ESKM)
165
53-1002923-01
Zoning considerations
3
The Local Name Server has 1 entry }
The nsshow command shows all devices on the switch, and the output can be lengthy. To
retrieve only the initiator PWWN, do a pattern search of the output based on the initiator Port
ID (a hex number). In the following example, The PID is 010600, where 01 indicates the
domain and 06 the port number.
FabricAdmin:switch> nsshow | grep 0106
N 010600; 2,3;
10:00:00:00:c9:2b:c9:3a
;20:00:00:00:c9:2b:c9:3a; na
3. Determine the target PWWN. Enter the nsscamshow command to review the remote switch
information. In the following example, the port name 20:0c:00:06:2b:0f:72:6d is the target
PWWN.
FabricAdmin:switch> nscamshow
nscamshow for remote switches:
Switch entry for 2
state rev owner
known v611 0xfffc01
Device list: count 13
Type Pid COS PortName NodeName
NL 0208d3; 3;
20:0c:00:06:2b:0f:72:6d
;20:00:00:06:2b:0f:72:6d;
FC4s: FCP
PortSymb: [55] "LSI7404XP-LC BR A.1 03-01081-02D FW:01.03.06 Port 1 "
Fabric Port Name: 20:08:00:05:1e:34:e0:6b
Permanent Port Name: 20:0c:00:06:2b:0f:72:6d
Port Index: 8
Share Area: No
Device Shared in Other AD: No
Redirect: No
Alternately use nscamshow | grep target PID to obtain the target PWWN only.
FabricAdmin:switch> nscamshow | grep 0208
NL 0208d3; 3;
20:0c:00:06:2b:0f:72:6d
;20:00:00:06:2b:0f:72:6d;
4. Create a zone that includes the initiator and a target. Enter the zonecreate command followed
by a zone name, the initiator PWWN and the target PWWN.
FabricAdmin:switch> zonecreate itzone, "10:00:00:00:c9:2b:c9:3a; \
20:0c:00:06:2b:0f:72:6d"
5. Create a zone configuration that includes the zone you created in step 4. Enter the cfgcreate
command followed by a configuration name and the zone member name.
FabricAdmin:switch> cfgcreate itcfg, itzone
6. Enable the zone configuration.
FabricAdmin:switch> cfgenable itcfg
You are about to enable a new zoning configuration.
This action will replace the old zoning configuration with the
current configuration selected.
Do you want to enable 'itcfg' configuration (yes, y, no, n): [no] y
zone config"itcfg" is in effect
Updating flash ...