Brocade Fabric OS Encryption Administrator’s Guide Supporting HP Secure Key Manager (SKM) and HP Enterprise Secure Key Manager (ESKM) Environments (Supporting Fabric OS v7.2.0) - Manual (Page 91)

Fabric OS Encryption Administrator’s Guide (SKM/ESKM) 71
53-1002923-01
Adding target disk LUNs for encryption
2
Adding target disk LUNs for encryption
You can add a new path to an existing disk LUN or add a new LUN and path by launching the Add
New Path wizard.
NOTE
Before you can add a target disk LUN for encryption, you must first configure the Storage Arrays. For
more information, see
“Configuring storage arrays” on page 75.
Complete the following steps to add a target disk LUN:
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box.
2. Select a group, switch, or engine from the Encryption Center Devices table, then select
Group/Switch/Engine > Disk LUNs from the menu task bar.
The Encryption Disk LUN View dialog box displays. (Refer to Figure 45 .)
FIGURE 45 Encryption Disk LUN View dialog box
The dialog box provides a convenient way to view and manage disk LUNs that are provisioned
from different hosts, to identify conflicts between configuration policies on storage systems,
and to provide a launching point for the Add New Path wizard for configuring multiple I/O paths
to the LUN.
The dialog box contains the following information:
• Storage Array selector: Determines which LUN paths are displayed in the table. Enables
you to select a storage array from the LUN view prior to launching the Add New Path
wizard. Only ports that belong to at least one target container are listed.
• Host selector: Used to select a host from the LUN view prior to launching the Add New Path
wizard. Only ports that belong to at least one target container are listed.