Setting up the local certificate authority (ca) on, Eskm/skm – Brocade Fabric OS Encryption Administrator’s Guide Supporting HP Secure Key Manager (SKM) and HP Enterprise Secure Key Manager (ESKM) Environments (Supporting Fabric OS v7.2.0) User Manual
Page 52
32
Fabric OS Encryption Administrator’s Guide (SKM/ESKM)
53-1002923-01
Steps for connecting to an ESKM/SKM appliance
2
Setting up the local Certificate Authority (CA) on ESKM/SKM
To create and install a local CA, complete the following steps:
1. Log in to the ESKM/SKM management web console using the admin password.
2. Select the Security tab.
3. Under Certificates & CAs, click Local CAs.
4. Enter information required by the Create Local Certificate Authority section of the window to
create your local CA.
•
Enter a Certificate Authority Name and Common Name. These may be the same value.
•
Enter your organizational information.
•
Enter the Email Address to receive messages for the Security Officer.
•
Enter the Key Size. HP recommends using 2048 for maximum security.
•
Select Self-signed Root CA.
•
Enter the CA Certification Duration and Maximum User Certificate Duration. These values
determine when the certificate must be renewed and should be set in accordance with
your company's security policies. The default value for both is 3650 days or 10 years.
5. Click Create.
The new local CA displays under Local Certificate Authority List. (Refer to
.)
NOTE
Fabric OS 7.1.0 will use SHA256 signatures for the TLS certificates used to connect to the ESKM 3.0.
FIGURE 11
Creating an HP ESKM/SKM local CA