Brocade Fabric OS Encryption Administrator’s Guide Supporting HP Secure Key Manager (SKM) and HP Enterprise Secure Key Manager (ESKM) Environments (Supporting Fabric OS v7.2.0) - Manual (Page 264)

244 Fabric OS Encryption Administrator’s Guide (SKM/ESKM)
53-1002923-01
Encryption group and HA cluster maintenance
6
Displaying the HA cluster configuration
NOTE
The correct failover status of an HA cluster will only be displayed on the HA cluster member nodes
in the encryption group.
1. Log in to the group leader as Admin or SecurityAdmin.
2. Enter the cryptocfg
--
show
-
hacluster
-
all command.
In the following example, the encryption group brocade has two HA clusters. HAC 1 is
committed and has two members. HAC 2 has one member and remains in a defined state until
a second member is added and the transaction is committed.
SecurityAdmin:switch>cryptocfg --show -hacluster -all
Encryption Group Name: brocade
Number of HA Clusters: 2
HA cluster name: HAC1 - 2 EE entries
Status: Committed
WWN Slot Number Status
11:22:33:44:55:66:77:00 0 Online
10:00:00:05:1e:53:74:87 3 Online
HA cluster name: HAC2 - 1 EE entry
Status: Defined
WWN Slot Number Status
10:00:00:05:1e:53:4c:91 0 Online
In the following example, the encryption group brocade has one HA cluster HAC3. The
encryption engine with the WWN of 10:00:00:05:1e:53:89:dd has failed over containers from
the encryption engine with the WWN of 10:00:00:05:1e:53:fc:8a it is offline.
SecurityAdmin:switch>cryptocfg --show -hacluster -all
Encryption Group Name: brocade
Number of HA Clusters: 1
HA cluster name: HAC3- 2 EE entries
Status: Committed
WWN Slot Number Status
10:00:00:05:1e:53:89:dd 0 Online - Failover active
10:00:00:05:1e:53:fc:8a 0 Offline
NOTE
In this particular case, the correct status of Failover active is displayed only if group leader
node is queried. If the other node is queried, Failover active is not displayed, which is not
consistent with the actual HA status.