Brocade Fabric OS Encryption Administrator’s Guide Supporting HP Secure Key Manager (SKM) and HP Enterprise Secure Key Manager (ESKM) Environments (Supporting Fabric OS v7.2.0) User Manual
Page 65
Fabric OS Encryption Administrator’s Guide (SKM/ESKM)
45
53-1002923-01
Creating an encryption group
2
Using this dialog box, you can select a key vault for the encryption group that contains the
selected switch. Prior to selecting your Key Vault Type, the selection is shown as None. The
dialog box contains the following information:
•
Key Vault Type:
If an encryption group contains mixed firmware nodes, the Encryption Group Properties
Key Vault Type name is based on the firmware version of the group leader.
•
Options are:
•
NetApp Link Key Manager (LKM)
•
RSA Data Protection Manager (DPM)
•
HP Secure Key Manager (SKM): The HP Key Vault Type name is shown as HP Secure
Key Manager (SKM); however, it is used to support both SKM and ESKM Key Vault
Types.
•
Thales e-Security keyAuthority (TEKA)
•
Tivoli Key Lifecycle Manager (TKLM)
•
Key Management Interoperability Protocol (KMIP)
8. Select HP Secure Key Manager (SKM) as the Key Vault Type.
Configuring key vault settings for HP Enterprise Secure Key Manager
(ESKM/SKM)
The following procedure assumes you have already configured the initial steps in the Configure
Switch Encryption wizard. If you have not already done so, go to
“Creating an encryption group”
shows the key vault selection dialog box for ESKM/SKM.
FIGURE 18
Select Key Vault dialog box for ESKM/SKM