Yokogawa ADMAG CA - Manual (Page 31)

IM 1E8B0-01E
5-2
5. BASIC OPERATING PROCEDURES
5.2 Types of Display Data
Three major types of data are displayed.
This mode displays flow rates
and totalization data.
Go to the setting mode and use
parameter "d1" to change
display items.
This mode can be called up by
pressing "SET" key while
pressing "SHIFT" key when
setting mode is displayed.
1. Flow Rate Date
Display Mode
Display Example)
%
(Flow rate %)
(Actual flow rate)
m 3 /h
(Flow rate totalization value)
(Alternate display of
flow rate % and flow
rate totalization value)
(Alternate display of
actual flow rate and flow
rate totalization value)
(Alternate display of
actual flow rate and
flow rate %)
2. Setting Mode
Display Example)
(Data item 02: 3 sec.dumping)
(Data item 03: Span 50.0)
(Data item C1: Zero adjust not possible)
(Data item d1: Selection of display items)
(Data item E1: Selection of totalization units)
3. Alarm Display Mode
Display Example)
(Error 07: Coil open)
(Error 06: Input signal error)
(Error 08: Incorrect span setting)
This mode is used to check
parameter content and rewrite
data. This mode can be called
up from the flow rate data
display mode by pressing the
"SET" key. When an alarm situation occurs,
this mode will replace the
current mode (flow rate or
setting mode) to show what type
of alarm has occurred.