Yokogawa ADMAG CA - Manual (Page 30)

IM 1E8B0-01E
5-1
5. BASIC OPERATING PROCEDURES
5. BASIC OPERATING PROCEDURES
All data settings can be performed with the three keys on the front panel (SET, SHIFT
and INC) or using a handheld BRAIN (BT) terminal.
The following sections describe basic data configurations and how to use the three panel
keys. (See Chapter 7 for information on BT operations.)
5.1 Liquid Crystal Display
Figure 5.1 shows the configuration of the ADMAG CA display panel (if equipped).
(Note: The figure shows display when fully lit)
(1) LED (red)
Normal operation: off
During alarm: flashes
(2) Delimiter
(3) Unit Display
Units displayed:
l:
liters
gal: gallon
m3: cubic meters
/h:
hours
/m: minutes
If other units are to be used, attach
labels giving the specific unit.
(4) Unit Label Location
(5) Data Display
(6) Decimal Point
(7) Setting Key
l gal m 3 /h /m
SET SHIFT INC
Figure 5.1 Configuration of Display
(1) LED (red) : This LED is off during normal operation and flashes when
an alarm condition has occurred.
(2) Delimiter : The delimiter " : " (colon) indicates that the displayed data
is in setting mode.
(3) Unit Display : Displays flow rate units. In order to display other units, the
required unit label should be selected from the provided
data sheets and attached as shown.
(4) Unit Label Location : To display units not on the LCD, select the required label
from the provided data sheets and attach it here.
(5) Data Display : Displays flow rate data, setting data and type of alarm
generated.
(6) Decimal Point : Displays decimal point in the data.
(7) Setting Keys : These keys are used to change flow rate data displays and
type of setting data.