Yokogawa ADMAG CA User Manual
User’s manual
Table of contents
Document Outline
- Contents
- 1. INTRODUCTION
- 2. HANDLING PRECAUTIONS
- 3. COMPONENT NAMES
- 4. INSTALLATION
- 5. BASIC OPERATING PROCEDURES
- 6. FUNCTION AND DATA SETTINGS
- 6.1 Flow Rate Span Setting
- 6.2 Measuring Mode Setting
- 6.3 Other Functions and Settings
- 6.3.1 Pulse Output
- 6.3.2 Display of Internal Totalization Values
- 6.3.3 Presetting for Totalization Display
- 6.3.4 Damping Time Constant
- 6.3.5 Current Output During Alarm Occurrence
- 6.3.6 Reversing Flow Direction
- 6.3.7 Limiting on Current Output
- 6.3.8 Alarm Output
- 6.3.9 Data Setting Enable/Inhibit
- 6.3.10 Procedure of Selecting Special Application Items
- 6.3.11 Rate Limit
- 7. OPERATION VIA BRAIN TERMINAL
- 7.1 Operation Via the BT200
- 7.2 Setting Parameters
- 7.2.1 Setting Flow Span
- 7.2.2 Measuring Mode Setting
- 7.2.3 Pulse Output (Refer to 6.3.1)
- 7.2.4 Display of Internal Totalization (Refer to 6.3.2)
- 7.2.5 Presetting Totalization Display (Refer to 6.3.3)
- 7.2.6 Damping Time Constant (Refer to 6.3.4)
- 7.2.7 Current Output During Alarm Occurrence (Refer to 6.3.5)
- 7.2.8 Reversing Flow Direction (Refer to 6.3.6)
- 7.2.9 Limiting Current Output (Refer to 6.3.7)
- 7.2.10 Alarm Output (Refer to 6.3.8)
- 7.2.11 Data Setting Enable / Inhibit (Refer to 6.3.9)
- 7.2.12 Procedure of Selecting Special Application Items (Refer to 6.3.10)
- 7.2.13 Rate Limit (Refer to 6.3.11)
- 7.2.14 User-Defined Units
- 7.2.15 Other Important Points to Note
- 8. ACTUAL OPERATION