beautypg.com

Ez zone series rm, Declaration of conformity, Watlow – Watlow EZ-ZONE RM-Scanner-Modul User Manual

Page 139: Iso 9001

background image

Watlow EZ-ZONE

®

RMS Module

136

Appendix

Declaration of Conformity

CE DOC EZ-ZONE RM-09-13

Page 1 of 1

EZ Zone Series RM

WATLOW

an

ISO 9001

approved facility since 1996.

1241 Bundy Blvd.
Winona, MN 55987 USA


Declares that the following Series RM (Rail Mount) products:
Model Numbers:

RM followed by additional letters or numbers describing use of up to four module

options of various inputs and outputs or communications.

Classification:

Temperature control, Installation Category II, Pollution degree 2

Voltage and Frequency:

SELV 24 to 28 V

 ac 50/60 Hz or dc

Power Consumption:

RMA models 4 Watts, any other RM model 7 Watts

Environmental Rating:

IP20


Meet the essential requirements of the following European Union Directives by using the relevant standards show
below to indicate compliance.

2004/108/EC Electromagnetic Compatibility Directive

EN 61326-1

2006

Electrical equipment for measurement, control and laboratory use – EMC
requirements, Industrial Immunity, Class A Emissions (Not for use in a
Class B environment without additional filtering).

EN 61000-4-2

2008

Electrostatic Discharge Immunity

EN 61000-4-3

2010

Radiated Field Immunity

EN 61000-4-4

2011

Electrical Fast-Transient / Burst Immunity

EN 61000-4-5

2006

Surge Immunity

EN 61000-4-6

2008

Conducted Immunity

EN 61000-4-11

2004

Voltage Dips, Short Interruptions and Voltage Variations Immunity

EN 61000-3-2

2005

Harmonic Current Emissions

EN 61000-3-3

1

2005

Voltage Fluctuations and Flicker

SEMI F47

2000

Specification for Semiconductor Sag Immunity Figure R1-1

1

NOTE: To comply with flicker requirements cycle time may need to be up to 160 seconds if load current

is at 15A, or the maximum source impedance needs to be < 0.13

. Control power input of RM models

comply with 61000-3-3 requirements.

2006/95/EC Low-Voltage Directive

EN 61010-1

2010

Safety Requirements of electrical equipment for measurement, control and
laboratory use. Part 1: General requirements

Compliant with 2002/95/EC RoHS Directive

Per 2002/96/EC W.E.E.E Directive

Please Recycle Properly


Joe Millanes

Winona, Minnesota, USA

Name of Authorized Representative

Place of Issue


Director of Operations

September 2013

Title of Authorized Representative

Date of Issue




Signature of Authorized Representative