6 jumper settings, Umper, Ettings – IEI Integration WAFER-945GSELVDS2 User Manual

Page 58: Figure 4-2: cf card installation

WAFER-945GSELVDS2

Page 46

Figure 4-2: CF Card Installation

4.6 Jumper Settings

NOTE:

A jumper is a metal bridge used to close

an electrical circuit. It consists of two or

three metal pins and a small metal clip

(often protected by a plastic cover) that

slides over the pins to connect them. To

CLOSE/SHORT a jumper means

connecting the pins of the jumper with

the plastic clip and to OPEN a jumper means removing the plastic clip

from a jumper.