IEI Integration WAFER-945GSELVDS2 - Manual (Page 103)

WAFER-945GSELVDS2
Page 91
ƒ Remote Access [Disabled]
Use the Remote Access option to enable or disable access to the remote functionalities
of the system.
Î
Disabled D EFAULT Remote access is disabled.
Î
Enabled Remote access configuration options shown below
appear:
Serial Port Number
Serial Port Mode
Redirection after BIOS POST
Terminal Type
These configuration options are discussed below.
ƒ Serial Port Number [COM1]
Use the Serial Port Number option allows to select the serial port used for remote
access.
ƒ COM1 D EFAULT
ƒ COM2
ƒ COM3
ƒ COM4
ƒ COM5
ƒ COM6
ƒ Base Address, IRQ [3F8h,4]
The Base Address, IRQ option cannot be configured and only shows the interrupt
address of the serial port listed above.
ƒ Serial Port Mode [115200 8,n,1]
Use the Serial Port Mode option to select baud rate through which the console redirection
is made. The following configuration options are available
ƒ 115200 8,n,1 D EFAULT