IEI Integration WAFER-945GSELVDS2 - Manual (Page 55)

WAFER-945GSELVDS2
Page 43
ƒ Turn all power to the WAFER-945GSELVDS2 off:
o When working with the WAFER-945GSELVDS2, make sure that it is
disconnected from all power supplies and that no electricity is being fed
into the system.
Before and during the installation of the WAFER-945GSELVDS2 DO NOT:
ƒ Remove any of the stickers on the PCB board. These stickers are required for
warranty validation.
ƒ Use the product before verifying all the cables and power connectors are
properly connected.
ƒ Allow screws to come in contact with the PCB circuit, connector pins, or its
components.
4.2.2 Installation Checklist
The following checklist is provided to ensure the WAFER-945GSELVDS2 is properly
installed.
ƒ All the items in the packing list are present
ƒ A compatible memory module is properly inserted into the slot
ƒ The CF Type I or CF Type II card is properly installed into the CF socket
ƒ The jumpers have been properly configured
ƒ The WAFER-945GSELVDS2 is inserted into a chassis with adequate
ventilation
ƒ The correct power supply is being used
ƒ The following devices are properly connected
o SATA drives
o Power supply
o USB cable
o Serial port cable
o Keyboard and mouse cable
ƒ The following external peripheral devices are properly connected to the
chassis:
o VGA screen
o USB devices