Ransburg MMA-570 Direct_Ind Charge Atomizer A13366 - Manual (Page 75)

Indirect Charge Schematic for Use Above 5,000-Ft. Sea Level
DO NOT attempt to hold a rag or a gloved hand against the bell edge to stop or slow down
a rotating bell.
DO NOT attempt to clean the bell edge while the bell is rotating.
DO NOT attempt to use sharp or abrasive materials to clean the bell, which will scratch or
damage the bell.
DO NOT attempt to place a high voltage probe on the bell edge unless rotation is full stopped.
DO NOT reuse an atomizer bell that shows signs of damage such as nicks, heavy scratches,
dents, or excessive wear (defined under “Bell Cup Cleaning” in the “Maintenance” section).
OPERATOR / MAINTENANCE
***WARNINGS***
LOW VOLTAGE CABLE CONNECTION FROM CONTROLLER
MMA-570 Direct/Indirect Charge - Maintenance
Ransburg
LN-9279-13 72