beautypg.com

Disassembly procedures, Ransburg – Ransburg MMA-570 Direct_Ind Charge Atomizer A13366 User Manual

Page 57

background image

MMA-570 PREVENTIVE MAINTENANCE SCHEDULE (Cont.)

Procedure

Yearly

6 Months

3 Months

Monthly

2 Weeks

Weekly

End of Shift

Mid-Shift

Replace Bell Cups

Replace Splash Plates
Inspect and Clean Spindle

Bore and Fluid Tube OD
Check High Voltage Contact

area for damage/arcing
Inspect for Fluid Leaks
Check Exterior of High

Voltage Ports for degradation
Check External Cup Flush

Carbide Tip for blockage

Frequency (Maximum)

DISASSEMBLY PROCEDURES

NOTE

NOTE

†

The outer protective cover may have

to be replaced more frequently than week-

ly. Daily inspection of the amount of paint

build-up on the cover will determine the

frequency of replacement.

†

For reassembly instructions, use the

reverse of the following disassembly

procedures.

†

To facilitate atomizer removal from

hose manifold, a robot program should

be made that purges all paints and sol-

vents from the MMA-570. Ideally it

would then position the bell assembly

in a bell removal position where the bell

cup is pointed downward at a 30° an-

gle. Any residual solvents would be con-

tained in the “J bend “ of the robot wrist.

†

All O-rings described in the “Mainte-

nance” section of this manual should be

lubricated with a food grade petroleum jel-

ly or with A11545 lubricant.

†

Direct Charge and Indirect Charge At-

omizer removal instructions are the same

with the exception of removing the high

voltage ring.

NOTE

W A R N I N G

!

†

Prior to removing applicator from the ro-

bot, the following tasks must be completed.

†

Robot put into E-stop mode, locked and

tagged out.

†

All fluid passages are cleaned, purged

out, and depressurized.

†

Air turned off.

Disassembly the turbine manifold assembly from

the mounting manifold assembly by unscrewing the

retaining ring counter-clockwise. Use of the span-

ner wrench to aid in removal may be necessary.

Once the high voltage ring and turbine manifold

assembly have been disassembled, remove all

tube connections to the mounting manifold and

remove the four (4) mounting screws.

• •

• •

• •

DAILY

MMA-570 Direct/Indirect Charge - Maintenance

Ransburg

LN-9279-13

54