FEC AFC1500 - Manual (Page 103)

AFC1500 Multi-2 Unit Hardware Manual (Rev2.1)
PAGE 5 - 59
Chapter 5: Control Interfaces
5.11.4 Ouput Signals (CH1 ~ CH16)
The Multi-2 Unit is capable of providing over 570 Output signals to indicate the status of the Multi-2
Unit and of all the AFC1500 SAN Controllers connected to it (up to 31 controllers).
See Section 4.7.3 for available output signals.
CH. No. Bit Signal
FEC Multi-2
Bank Bit
Output CH.
No.01
0bit Total Reject 1 1
1bit Total Accept 1 2
2bit Abnormal 1 3
3bit Ready 1 4
4bit Busy 1 5
5bit End 1 6
6bit Sequence Output 0 1 7
7bit Sequence Output 1 1 8
8bit Sequence Output 2 1 9
9bit Sequence Output 3 1 10
10bit Spindle in Bypass 1 11
11bit Current Warning 1 12
12bit Spindle No.1 Accept 1 13
13bit Spindle No.1 Reject 1 14
14bit Spindle No.1 ABN. 1 15
15bit Spindle No.1 BYP 1 16
Output CH.
No.02
0bit Spindle No.2 Accept 1 17
1bit Spindle No.2 Reject 1 18
2bit Spindle No.2 ABN 1 19
3bit Spindle No.2 BYP 1 20
4bit Spindle No.3 Accept 1 21
5bit Spindle No.3 Reject 1 22
6bit Spindle No.3 ABN 1 23
7bit Spindle No.3 BYP 1 24
8bit Spindle No.4 Accept 1 25
9bit Spindle No.4 Reject 1 26
10bit Spindle No.4 ABN. 1 27
11bit Spindle No.4 BYP 1 28
12bit Spindle No.5 Accept 1 29
13bit Spindle No.5 Reject 1 30
14bit Spindle No.5 ABN. 1 31
15bit Spindle No.5 BYP 1 32
Output CH.
No.03
0bit Spindle No.6 Accept 2 1
1bit Spindle No.6 Reject 2 2
2bit Spindle No.6 ABN 2 3
3bit Spindle No.6 BYP 2 4
4bit Spindle No.7 Accept 2 5
5bit Spindle No.7 Reject 2 6
6bit Spindle No.7 ABN 2 7
7bit Spindle No.7 BYP 2 8
8bit Spindle No.8 Accept 2 9
9bit Spindle No.8 Reject 2 10
10bit Spindle No.8 ABN. 2 11
11bit Spindle No.8 BYP 2 12
12bit Spindle No.9 Accept 2 13
13bit Spindle No.9 Reject 2 14
14bit Spindle No.9 ABN. 2 15
15bit Spindle No.9 BYP 2 16
：
CH. No. Bit Signal
Output CH.
No.16
0bit 8 1
…
15bit 8 32
The CH. No. at the Master input side differs according to node address settings.
Please check before operating the unit.
These Output signals are user
configurable using the AFC User
Console Software and may be
programmed on any designated
bit.
The Output signal mapping
shown is only an EXAMPLE.
The signals may be programmed
for placement in ANY bit
position.