Micromod MOD: 30ML Operation and Template Setup User Manual
Page 64
MOD 30ML Operation
APPENDIX A - EVENT CODES
A-2
Table A-2. Event Codes, Description and Action
Block
Type Codes
Full Message Text
Description/Action
AIN
4
I/O COMMUNICATIONS ERROR
Diagnostic report of a communications problem.
AIN
5
AIN (MODULE) ERROR
Output circuit reported an output too low or too
high error.
AIN
6
MODE SET TO AUTO
Information only.
AIN
7
MODE SET TO MANUAL
Information only.
AIN
8
CJC MODE SET TO AUTO
Information only.
AIN
9
CJC MODE SET TO MANUAL
Information only.
AOM
4
BLOCK MODE SET TO AUTO
Information only.
AOM
5
BLOCK MODE SET TO MANUAL
Information only.
AOM
6
I/O MISMATCH
A configured slot is either empty or the installed
module does not match the slot configuration.
AOM
7
AO COMMUNICATIONS ERROR
One of the following conditions was detected:
• There is a checksum error in the
communications between this block and the
module.
• The select circuit, which is used to
communicate with the module, has a
diagnostic error. In this case, all modules
report a communications error.
AOM
8
AO MODULE ERROR
The module has reported an error which is
identified by an extended error code. The error
codes can be viewed via the Extended Error
(EXTERR).
AOUT
4
BLOCK MODE SET TO AUTO
Information only.
AOUT
5
BLOCK MODE SET TO MANUAL
Information only.
AOUT
6
AOUT COMMUNICATIONS ERROR
Diagnostic report of a communications problem.
AOUT
7
AOUT (MODULE) ERROR
Output circuit reported an output too low or too
high error.
CJI
0-4
See TI 0-4.
CJIM
4
BLOCK MODE SET TO AUTO
Information only.
CJIM
5
BLOCK MODE SET TO MANUAL
Information only.
CJIM
6
I/O MISMATCH
A configured slot is either empty or the installed
module does not match the slot configuration.
CJIM
7
I/O COMMUNICATIONS ERROR
One of the following conditions was detected:
• A checksum error in the communications
between this block and the module.
• The select circuit, which is used to
communicate with the module, has a
diagnostic error. In this case, all modules
report a communications error.
CJIM
8
CJC MODULE ERROR
The module has reported an error which is
identified by an extended error code. The error
codes can be viewed via the Extended Error
(EXTERR).