Micromod MOD: 30ML Operation and Template Setup - Manual (Page 14)

MOD 30ML Operation
SETUP
2-4
Table 1. Device Status
Step Step Description Line 1 Line 2 Line 6 Entry Description
1 Device Status
∇ moves down to Step 1A
NXT goes to Step 2 (Setup)
PRV goes to Step 6 (Template)
*DEVICE* NOT CFGD
or
DEV TAG
DEV STAT See Table 2 for step 2 (Setup)
See Table 6 for step 6 (Template)
These steps are protected by the
CONFIG password. Enter proper
password, if used, to move down.
1A
Device Status State Command
∇ ∆ changes state on line 6
ENT enters device state
NXT, PRV change step
DEV STAT INSTATE DEFAULT DEFAULT (DEF)
HOLD (HLD)
HOLD WST (Hold with Warm Start)
RUN (RUN)
RUN WST (Run with Warm Start)
see Device States.
1B
Device Status Shutdown (Entry)
∇ moves down to Step 1B1.
DEV STAT SHUTDOWN NO
YES
Shutdown status is a debug tool
used to read specific instrument
registers. NO means no shutdown
is present. YES indicates a
shutdown. Record the information
on pages 1 to 5 and report them
when requesting a repair.
1B1 Shutdown Page 1
NXT, PRV change step
SYSPI 1
XXXXXXXX
Line 1 can be: Sxrrrr where
x (shutdown) = Y (yes) or N (no) and
rrrr = WDOG (Watchdog),
SPI (Spurious interrupt),
BMCK (Bad main database checksum),
BDCK (Bad default database
checksum), BECK (Bad EEPROM
checksum), BRAM (Bad RAM), DMA
(DMA error), IOSO (IO Stack Overrun),
FPCF (Faceplate comm. failure).
1B2 Shutdown Page 2
NXT, PRV change step
SYSPI 2
HH:MM:SS
MM/DD/YY
Time and date of shutdown or
of acknowledge shutdown.
1B3 Shutdown Page 3
NXT, PRV change step
SYSPI 3
XXXXXXXX
XXXXXXXX
Record number.
1B4 Shutdown Page 4
NXT, PRV change step
SYSPI 4
XXXXXXXX
XXXXXXXX
Record number.
1B5 Shutdown Page 5
∇ ∆ select YES/NO
NXT, PRV change step
SYSPI 5
ACK SD NO
Yes acknowledges shutdown,
restarts instrument and clears
registers. If acknowledge fails,
instrument will not restart.
1B6 Device Status Shutdown (Exit)
∆ moves up to Step 1B
NXT, PRV change step
SYSPI 6
DEV STAT
1C Device Status Commands (Entry)
∇ moves down to Step 1C1
DEV STAT COMMANDS
1C1
Clear Queue Command
∇ ∆ select YES/NO, ENT enters.
NXT, PRV change step
COMMANDS CLR Q NO Use to clear system event queue.
Press ENT after selecting YES.
1C2
Clear Maximum Scan Times
∇ ∆ select YES/NO, ENT enters.
NXT, PRV change step
COMMANDS CLR MT NO Use to clear maximum scan times
for all scan groups.
Press ENT after selecting YES.
1C3
Global Acknowledge Command
∇ ∆ select YES/NO, ENT enters.
NXT, PRV change step
COMMANDS ACK ALL NO Use to send global acknowledge
command causing all diagnostics,
alarms and notification/request
messages to be acknowledged.
Press ENT after selecting YES.