6 check / shadow run – FlexLink Elevator Руководство пользователя User Manual
Page 64
Installation and adjustment
56
5112204
5.6
Check / Shadow run
In this paragraph the elevator will be checked in a semiloaded condition
with all safety provisions activated. If during the shadow run irregular
sounds or other anomalies occur or if the elevator does not meet the spec-
ification or if with a test of ALL products some of these do not fit on the track
or get stuck or slip, the machine may not be tested further and advice
should be obtained.
Carry out the check
First the elevator is to be put into operation in order to carry out the checks
required. The elevator will run with semiload while the specified products
are transported through the elevator. If no unusual situations occur, the
check of the elevator and the associated safety provisions can be started.
Check elevator
Below a check table is set up with respect to how the elevator can be
checked for a number of items.
Checklist
No. Check
Remarks
1.
Does excessive noise occur.
Yes / No
This may occur because the tension of the
chain is not correct, lifting device are loose or a
sprocket wheel is not aligned well (see
. ‘troubleshooting
list’).
2.
There is a ticking sound.
Yes / No
This may occur because the tension of the
chain is not correct, lifting device are loose or a
sprocket wheel is not aligned well (see
. ‘troubleshooting
list’).
3.
Are the lifting device strongly
moving at any place in the
elevator.
Yes / No
This may occur as there are some loose lifting
device (see
.
‘troubleshooting list’)
4.
Are lifting device touching the
frame, the guide, the guard or
anything else.
Yes / No
Adjust the lifting device.
5.
Do all products fit on the
track.
Yes / No
Check in the technical specification whether the
product dimensions are correct.