FlexLink Elevator Руководство пользователя - Manual (Page 47)

Installation and adjustment
Create
d
by EBCCW
0
0
:06
39 5112204
5.2 Mechanical assembly
5.2.1 Integration in a (transport) system
The elevator is a machine that is integrated in a system of conveyors. This
means that an input and output are to be connected to it. If the elevator is
to be fitted into an existing situation, this usually gives more problems than
in a completely new situation. In both cases one should aim at optimum
functioning.
5.2.2 Floor construction
Below a number of items are given which should be paid attention to during
integrating a elevator as floor construction.
Tools
• Before placing the elevator first make sure that it is placed on the
right place and at the right height. For setting the correct height
the adjusting feet mounted under the elevator can be used.
• Now that the correct height has been established, the connecting
tracks at the lower and upper ends of the elevator can be adjust-
ed. A special sliding bridge or roller bridge may be needed for a
safe transfer of products.
• After the elevator has been well integrated in the system, the ele-
vator can be attached to the floor surface. This can be done by an-
choring the adjusting feet firmly to the floor or/and connect
through the holes shown in the picture.
• At installation, dismount transport protections and replace them
with air vents.
For more information, see the separate manual from gear box
manufacture.
NB: The quality of integration in the system is coresponsible for
the good functioning of the elevator. Therefore make sure this is
done properly!
Opend end spanner Ring spanner Plastic hammer
Air vents