Franklin Fueling Systems TS-TPI - Manual (Page 40)

TS-TPI DATA AND REPORTS Page 6-9 6
TS-TPI Installation and Wiring Guide
System Setup Report
Additions --
TPI/Pump Controller Setup
Tank Sentinel Setup reports show the entire
configuration of the Tank Sentinel programming.
The TPI/Pump Controller section is located in
the System Setup Report, below the Sensors
section and above (before) the Cathodic
Protection section. Here is a sample of how it
looks:
Please Note:
PUMP HEIGHT will be in inches or
centimeters, depending on what Units
are set in the program.
If TPI is not enabled, then this data
will not be displayed or printed.
The SYSTEM Setup report includes the infor-
mation about TPI and Pump Controllers. Here
is how to access it...
How to print the report:
Description of Steps:
Here is the Tank Sentinel display in RUN
MODE, showing SYSTEM, TANK, SENSOR,
etc. are all OKAY...
1) Press the REPORT key to display the
SELECT REPORT GROUP menu...
2) Press the DOWN key to show the SETUP
menu selection...
Here is the SELECT REPORT GROUP menu
showing the SETUP menu selection...
3) Press the M3 key to display the SELECT
SETUP REPORT selection menu...
TPI
ENABLED YES
ADDRESS 80
PUMP CONTROLLERS
NUMBER OF PUMPS 5
PUMP 1
NAME PUMP 1
TYPE SCI
GROUP 1
ADDRESS 0
TANK 1
PUMP HEIGHT 7.00 IN
PUMP GROUPS
GROUP 1
PUMPS 1, 2
TYPE MAST SLAV
MODE PRIORITY
RESERVE 20
TANKS 1, 2
SELECT REPORT GROUP (MORE)
SENSOR ALARM SETUP
M1 M2 M3 M4
K W
DOWN
SPACE
SYSTEM TANK SENSOR LINE
OKAY OKAY OLAY OKAY
J W
REPORT
9