Franklin Fueling Systems TS-TPI User Manual
Page 25
4
Page
4-8
TS-TPI SETUP PROGRAMMING
TS-TPI Installation and Wiring Guide
TPI Group Menu
•
TYPE “READ ONLY”
•
MODE (user entry)
•
RESERVE (user entry)
TYPE “READ ONLY”
Description of Steps:
Here is the main TPI menu, displaying
ENABLE, PUMP and GROUP...
1) Press the M3 key to display the TPI
GROUP menu...
Here is the TPI GROUP menu displaying
GROUP numbers 1 to 4 (zero LS-300s)
2) Press the (M) key of the group number to
be displayed. For this example, press M2 to
display the GROUP 2 menu...
Here is the GROUP 2 menu displaying TYPE
and MODE...
3) Press the M1 key to display the TYPE of
group as detected during Auto-Configuration.
This is a READ ONLY field.
In this example, the type “MAST SLAV” is
displayed...
4) Press the CANCEL key to return to the
GROUP 2 menu.
To repeat the user entry steps for each
group, press CANCEL again to display the
TPI Group menu.
GROUP MENU NOTES
The Group menu is not available when pump controllers
are not connected/programmed with the TS-TPI device.
The Group menu name appears on the display but it does
not function.
Group 1 is removed from the display if one LS-300 is
connected to the TS-TPI. Groups 1 and 2 are removed
when two LS300s are connected. All Groups are displayed
if zero LS-300s are connected.
CANCEL
TPI
ENABLE
PUMP
GROUP
M1
M2
M3
M4
TPI GROUP
GROUP1
GROUP2
GROUP3
GROUP4
M1
M2
M3
M4
GROUP 2
TYPE
MODE
M1
M2
M3
M4
TYPE GROUP 2
READ ONLY
MASTER SLAV
NOTE: Please read the MODE Notes to gain a better understanding of the MODE
and RESERVE features.
NOTE