Xylem System 5000 User Manual - Manual (Page 89)

Modbus
87
Using an Existing Port
Adding additional Tasks to existing
Modbus setups is a simple process
and can be done through the Select
Input/Add Output selection screens.
Simply select the desired Modbus
Master/Slave (port) and press the OK
button to open the Modbus Properties
screen.
Port Settings
Changing the port of a Modbus setup can be done via the Modbus Master/Slave Properties
screens, accessible from the Select Input/Add Output screens, as well as the Listening Ports
Setup screen for Slave setups. To change the port, press the Edit button next to the current Port.
To modify the settings of a Serial port, press the Settings button on the Modbus Master
Properties screen or the Edit button on the Edit Listening Port screen. Modbus Master setups can
also specify a connection timeout (in milliseconds) as well as a retry count for each register
request.