Xylem System 5000 User Manual - Manual (Page 121)

In order to communicate with the System 5000
™
using a serial port or USB port, a one-time
setup on the desired port needs to be performed to first have the port appear as a modem, and
second to set up Dial-up Networking to make the connection. Once these steps have been
completed, an icon can be placed on the Desktop of the PC to make future connections quick
and simple.
Before proceeding, verify the System 5000
™
has been set up and configured as noted above and
the PC is connected to the System 5000
™
by either a USB or serial cable. Note that a
null modem adapter is required for communication if a serial cable is being used.
Connect With A PC
119
Select Install from a list or specific
location (Advanced) and press the Next
button.
Check the Include this location in the
search: and press the Browse button.
Select the folder or location of the
driver files that were saved previously
and press the OK button. Then press
the Next button.
Once the driver has been found and
begins to be installed, a warning
message may appear. Press the
Continue Anyway to allow the driver to
be installed properly.
Once the driver has been installed,
press the Finish button to exit the driver
installation.
PC Networking Setup