EVS MulticamLSM Version 10.03 - July 2010 Operating Manual - Manual (Page 193)

Issue
10.03.C EVS Multicam Version 10.01 – Operating Manual
EVS Broadcast Equipment SA – July 2010
184
Glossary
HANC LTC Horizontal Ancillary timecode LTC as defined in
the XMPTE 259M and RP188 standards.
HANC VITC Horizontal Ancillary timecode VITC as defined in
the XMPTE 259M and RP188 standards.
LTC Longitudinal (or Linear) timecode (LTC) is a
timing signal that is part of an audio tape
recording. It is recorded on a track that runs
lengthwise along the tape, which is why it is
called longitudinal. It can only be read if the tape
is playing.
LTC table Timecode jump table in which the jumps in LTC
timecodes are stored.
OSD On-Screen Display. Information displayed on the
output monitor.
Protected clip Clip that has been created on an EVS server and
that cannot be manually deleted by users.
Such clips are clips:
• stored on server pages defined as protected
pages in the parameters,
• stored on pages dedicated to a protocol,
• inserted in a playlist or timeline,
In this case, the user can however force the
deletion.
• being on-air,
In this case, the clip is rather ‘locked’, not
really ‘protected’.
Protect IN point Position, i.e. timecode, which represents the first
image of the protected video material for a clip,
i.e. the first image before the IN guardband.
Protect OUT point Position, i.e. timecode, which represents the last
image of the protected video material for a clip,
i.e. the last image after the OUT guardband.
Short IN point Position, i.e. timecode, which represents the first
image of a clip. This is also called IN point in
this user manual.
Short OUT point Position, i.e. timecode, which represents the last
image of a clip. This is also called OUT point in
this user manual.