EVS MulticamLSM Version 10.03 - July 2010 Operating Manual - Manual (Page 162)

EVS Multicam Version 10.03 – Operating Manual
EVS Broadcast Equipment SA – July 2010
Issue
10.03.C
153
13.4.4 H
OW TO
I
NSERT
R
EMOTE
C
LIPS
I
NTO A
P
LAYLIST
1. Select the Remote LSM via the Network menu.
2. Select a remote clip in the banks. The corresponding F_ key lights red.
3. Press ENTER on the Remote.
4. Repeat the 3 first steps as necessary until last clip is entered.
In Playlist Edit mode, the remote display gives all needed information regarding
this playlist and this information is updated each time a clip is stored in the
playlist.
13.4.5 H
OW TO
R
OLL A
P
LAYLIST
W
ITH
R
EMOTE
C
LIPS
1. Once the playlist is cued and ready to roll, select the playlist from the playlist
bank.
2. Press the PLST key on the Remote Panel.
3. Move the lever to start the playback or press the PLAY key.
C
LIPS
U
NAVAILABLE ON THE
XN
ET
N
ETWORK
While the playlist is rolling on air, a remote clip might be unavailable due to a
network problem or simply if the Remote LSM has left the network. In this case,
the clip is marked as ‘NOT AVAILABLE’ on the playlist screen and is skipped when
the playlist is rolling. If a clip is made available again, it will re-appear
automatically and be played at the right position in the playlist.
Unavailable clips are shown on the VGA monitor but not on the LCD of the remote.
The operator can decide to definitively remove the unavailable clips from all local
playlists by using the Clr Unav. function (SHIFT+B) in Playlist Edit mode. Note
that this function is only visible when unavailable clips are present and with Split
Audio Editing turned off.
PL11 LSM01 MICHEL LOC TDUR=00:00:58:22
152A/03 Clip
0112 00:01:20 Unk W00:10
111A/04 Clip Foot 00:10:25 Unk W00:10
112B Clipname4567 00:04:29 Unk W00:10
112B/02 Clip 0113 00:01:10 Unk W00:10
552C/08 noname01234 00:02:50 Unk W00:10
EFFECT EDIT ALL
INSERT SPEED FX Dur DELETE