EVS MulticamLSM Version 10.03 - July 2010 Operating Manual - Manual (Page 12)

EVS Multicam Version 10.03 – Operating Manual
EVS Broadcast Equipment SA – July 2010
Issue
10.03.C
3
1. Initial Configuration
1.1 APPLICATION SELECTION
The EVS software is used for configuration and maintenance operations. It is also
used to select which application configuration to run, since EVS disk recorders
have the ability to run various configurations (LSM 2REC 4PLAY, LSM 3REC
3PLAY, LSM 4 REC 2 PLAY, SLSM, SLSM+1REC, etc.). In the associated AVCFG
module, you can also specify the channel configuration you want to use and
several audio and video parameters.
When turning on the EVS mainframe, the first step is the PC boot sequence, then
the EVS software is started:
• If a default application has been previously selected, this application will start
automatically after a few seconds if no key is hit.
• If a default application hasn't been defined or if the space bar is hit, the system
will remain in the EVS main menu and wait for the operator's next command.
You will find complete information about regarding the EVS Menu in the XT Tech
Ref Software manual.