EVS MulticamLSM Version 10.03 - July 2010 Operating Manual - Manual (Page 136)

EVS Multicam Version 10.03 – Operating Manual
EVS Broadcast Equipment SA – July 2010
Issue
10.03.C
127
H
OW TO
P
ERFORM AN
A
UDIO
S
PLIT
When you perform an audio split, you specify the TC for the beginning or end of
the audio transition. In this case, you can choose whether you perform an audio
delay or advance.
1. Enter the Playlist Edit mode.
2. Browse to the desired clip in the playlist.
3. Press to highlight V Base (SHIFT+A).
4. Press to highlight A Split (D).
5. Jog to the point where you want to set your transition.
6. Do one of the following:
o Mark an OUT point if you do an audio delay.
o Mark an IN point if you do an audio advance.
The value entered will be present on the PRV screen when the clip is next to play
in a playlist.
11.15.9 P
ERFORMING
A
N
‘A B
ASE
’ E
DIT
In an A Base edit, you delay or advance the beginning of the video transition
compared to the audio transition of the clip.
H
OW TO
P
ERFORM A
V
IDEO
A
DVANCE
In this case, the beginning of the video transition will be advanced compared to
the audio transition.
1. Enter the Playlist Edit mode.
2. Browse to the desired clip in the playlist.
3. Press SHIFT + A Base (B).
4. Press to highlight V Advance (SHIFT+A)
5. At the on screen prompt, enter a value on the F_ keys including leading zeros
(0+2+1+2= 2:12), OR move the lever and press ENTER.
The value entered will be present on the PRV SCREEN when the clip is next to
play in a playlist.