EVS MulticamLSM Version 10.03 - July 2010 Operating Manual - Manual (Page 187)

Issue
10.03.C EVS Multicam Version 10.01 – Operating Manual
EVS Broadcast Equipment SA – July 2010
178
Setting Description Values
2 n d Lever Secondary lever range to be applied for
playing back material recorded on the
hypermotion camera. 0-1000, +- 1000
(default)
18.2.3 K
EY
C
OMMANDS
The following table shows the various commands you can use on the Remote
Panel to control the hypermotion camera, as well as the corresponding command
on the hypermotion camera:
Command on
Remote Panel Command on
hypermotion camera Description
PLAY Play Initiates a replay on the current memory
block.
SHIFT-PLAY - Initiates a replay on the current memory
block at the speed defined in the
PGMSpeed parameter.
Mark Mark cue point With a single-block memory, it marks a
cue point of the current block.
This is not available on all cameras with
multiple-block memory.
Last cue Search With a single-block memory, it goes to
the previous cue point if cue points have
been defined.
With a multiple-block memory, it goes to
the previous cue point of the current
block if cue points have been defined on
this block.
When no cue point has been defined on a
block, it stops the recording and cues to
the first recorded frame.
RECORD Start ARM Initiates the loop recording on the current
memory block.
TAKE Trig/Stop rec With a single-block memory or when the
last block is reached, this stops the
recording.
With a multiple-block memory, it stops
the record on the current block and starts
automatically the record on the next
block.
Lever - Plays the material specified as secondary
lever range for the hypermotion function.