beautypg.com

6 navigating among swap points, 17 replace function, 1 introduction – EVS MulticamLSM Version 10.03 - July 2010 Operating Manual User Manual

Page 144: 2 entering the replace function, 3 replace edit and replace playback modes, The replace edit mode, Unction, Tion, 17 ‘replace function

background image

EVS Multicam Version 10.03 – Operating Manual

EVS Broadcast Equipment SA – July 2010

Issue

10.03.C


135

11.16.6 N

AVIGATING

A

MONG

S

WAP

P

OINTS

When the operator is in Swap mode, the previous swap point can be reached by
pressing the Go to In button on the Remote. The next swap point is reached by
pressing the Go to Out button. The function works in loop mode.

11.17 REPLACE FUNCTION

11.17.1 I

NTRODUCTION

The purpose of the Replace function is to automate a routine used by operators to
create effects in a playlist: the operator would loop a section or an entire playlist
back to themselves and, during the playback, add some effects externally (graphic
insertion for instance) or internally (changing the speed).

While the operator would play the playlist back, and insert the requested effects,

the playback result would be re-injected into the playlist from a predefined IN
frame. The OUT point of the replaced section would be predefined or manually
defined in the record process.

Note

The Replace function is not allowed on playlists containing growing clips.

11.17.2 E

NTERING THE

R

EPLACE

F

UNCTION

A secondary menu with the Replace function has been added to the Playlist Edit
mode. Pressing Menu in Playlist Edit mode brings up the following menu:

Clr Unav.

OtherAng

Replace

MakeLoc

Redo

Undo

Select Replace in this secondary menu to enter the Replace function.

11.17.3 R

EPLACE

E

DIT AND

R

EPLACE

P

LAYBACK

M

ODES

Similar to the playlist, the Replace function has two modes:

T

HE

R

EPLACE

E

DIT MODE

This mode makes it possible to specify the following information for the Replace:

IN point and OUT point, for the section to replace in the playlist. The OUT point

can also be defined during the Replace itself.

Loop mode parameters. See also the section ‘Loop Mode in the Replace

Function’, on page 138.

In the Replace Edit mode, the playlist is considered as one entity on which you
can mark one IN point and one OUT point (pressing the IN and OUT points does
not retrim the current playlist clip).