2 general process with single-block memory, 3 general process with multiple-block memory, Eneral – EVS MulticamLSM Version 10.03 - July 2010 Operating Manual User Manual
Page 189: Rocess with, Ingle, Lock, Emory, Ultiple

Issue
10.03.C
EVS Multicam Version 10.01 – Operating Manual
EVS Broadcast Equipment SA – July 2010
180
18.3.2 G
ENERAL
P
ROCESS WITH
S
INGLE
-B
LOCK
M
EMORY
The general recording and playback process when controlling the camera using a
single-block memory is the following:
1.
Start the recording on the camera by pressing RECORD on the Remote.
2.
During the recording, you can set cue points on the recorded material by
pressing MARK.
3.
Stop the recording in one of the following ways:
•
Pressing Last cue will position the camera on the previous cue taking the
pre-roll into account.
•
Jogging the dial will position the camera on the requested image.
•
Pressing TAKE will only stop the recording.
4. Press
PLAY to start the playback.
During the playback, the material played on the hypermotion camera is
recorded into the server via the SDI connection.
18.3.3 G
ENERAL
P
ROCESS WITH
M
ULTIPLE
-B
LOCK
M
EMORY
The general recording and playback process when controlling the camera using a
multiple-block memory is the following:
1.
Press the softkey (A to D) corresponding to the memory block (1 to 4) on
which you want to record the material.
2.
Start the recording on the camera by pressing RECORD on the Remote. The
material start recording in loop mode on the given block.
3.
When you want to start recording on another block, press TAKE.
4.
Stop the recording in one of the following ways:
•
Pressing Last cue will position the camera and cues to the first recorded
frame of the block.
•
Jogging the dial will position the camera on the requested image.
•
Selecting another block, which loads the first frame recorded on this block
in play mode.
5. Press
PLAY to start the playback.
During the playback, the material played on the hypermotion camera is
recorded into the server via the SDI connection.