EVS MulticamLSM Version 10.03 - July 2010 Operating Manual - Manual (Page 190)

EVS Multicam Version 10.03 – Operating Manual
EVS Broadcast Equipment SA – July 2010
Issue
10.03.C
181
18.3.4 C
REATING A
C
LIP
W
ITH THE
M
ATERIAL FROM THE
H
YPERMOTION
C
AMERA
When the camera is replaying its content onto the EVS server, it is possible to clip
it automatically directly from the LSM Remote controlling the camera. Using the IN
and OUT keys and the F_ Keys, the operator can clip the record train
corresponding to the hypermotion camera and store it on a clip position. That way
it is possible to clip the hypermotion camera without having the control on a PGM,
and without waiting for all the content to be recorded on the server.
When you have played back the material recorded on the hypermotion camera, it is
available in the record train of the camera defined in the Recorder setting (p6.4,
F2). You can then create clips with this material.
To do this, proceed as follows:
1. Come back to the LSM mode with SHIFT+D (in Hypermotion+LSM mode) or
use another Remote Panel (in Hypermotion only mode).
2. Load the relevant record train on the PGM.
3. Jog in the material and add a MARK IN, MARK OUT as usual to create the
requested clip.