EVS MulticamLSM Version 10.03 - July 2010 Operating Manual - Manual (Page 182)

EVS Multicam Version 10.03 – Operating Manual
EVS Broadcast Equipment SA – July 2010
Issue
10.03.C
173
Command Description
Å WP Æ To move the separation line
V SPLIT /
H SPLIT
Toggles between horizontal and vertical Split screen menus
SWAP To swap sources from both sides
SYNC To synchronize the selected PGM with the other one. Press this
button and select the PGM to use as a reference.
Press the LEFT key to take control of the left side of the screen, and recall the
desired clip for this side. Use the command knob to search inside the clip until the
desired picture is reached.
Press the RIGHT key to take control of the right side of the screen, and repeat the
same operation with the clip you want to display on the right side.
You can also shift horizontally the clips on both sides, so that the action is in the
centre of the picture.
Press the SHIFT key (D) to enter this mode. The menu will change, as shown
above.
Press the Å LF Æ key, and move the command knob to centre the left side
picture.
Press the Å RG Æ key and do the same operation for the right side picture.
To restore the default positions, press CLEAR + Å LF Ж, Е RG Æ.
Press the Å WP Æ key allows moving the border. To restore the default position
of the border, press CLEAR + Å WP Æ.
To exit the SHIFT mode, press the SHIFT key (D) again.
If working in network mode, split screen can be performed on remote clips as well
as on local clips.