EVS MulticamLSM Version 10.03 - July 2010 Operating Manual - Manual (Page 124)

EVS Multicam Version 10.03 – Operating Manual
EVS Broadcast Equipment SA – July 2010
Issue
10.03.C
115
11.13.2 H
OW TO
A
DD
/R
EMOVE AN
A
UXILIARY
A
UDIO
C
LIP TO A
P
LAYLIST
1. Make the Aux. Clip button active by selecting a clip from the clip bank. This
can be done outside of the PLST EDIT mode, or in PLST EDIT mode with PRV
CTRL ON. You will see the Aux Clip option appearing in the secondary menu
on the LCD of the Remote Panel.
2. Then press MENU to call the secondary menu, then Aux Clip button
(SHIFT+B): the ID of the Aux Clip appears in the title bar of the Playlist screen
(F10)
3. To remove the current aux. clip, load the aux clip, call the secondary menu by
pressing MENU, then press CLEAR + SHIFT + (B) (Aux. Clip) on the Remote.
11.14 TRANSITION EFFECTS
11.14.1 D
ESCRIPTION
You can apply effects on the audio and video transitions of a clip in a playlist. For
each transition, you define the effect type and duration.
The Split Audio option will be handled in the next chapter.
Normal Playlist with Cuts
Playlist with 1:00 sec Effect Duration
In an LSM playlist, the video and audio effects end at the OUT point of a clip, so
the duration of clips is shortened by the length of the effect.