RIDGID NaviTrack II - Manual (Page 9)

NaviTrack® II
8
Adding Frequencies
Additional frequencies can be added to the Main Menu list
of available frequencies by going to the Frequency Select
Submenu and selecting the desired mode.
To activate frequencies go down to the Frequency Selection
submenu, and highlight the category of the
desired frequency.
Figure 13: Selecting a Frequency Category
Then use the arrow keys to scroll through the available
frequencies. Highlight the desired frequency to add it to the
Main Menu list.
Figure 14: Highlighting a Frequency To Activate
Checking a frequency (using the Select key) will include it in
the activated frequencies on the Main Menu. Unchecking it
will hide it from the active frequency set.
Figure 15: Selecting a Frequency to Activate
Checking or unchecking a frequency, selects or deselects it
to be included on the Main Menu. To switch frequencies from
among those that are activated, press the Menu key and go
down the Main Menu to the desired frequency; then return
to the map display. The NaviTrack® II will show the chosen
frequency and its icon on the left of the screen.
Pressing the Menu key when done will return to the map
display, one menu level at a time.
Selected frequencies in the activated set can be switched while
the NaviTrack® II is in use, by pressing the Frequency button.
The NaviTrack® II will cycle through the set of active frequencies
from low to high and repeat. Unchecking a frequency in the
Main Menu will deselect it even though it is “activated”, and it
will then not appear when pressing the Frequency button.
NOTE: If a frequency seems to have “disappeared” first look to
make sure it is in the Main Menu activated frequencies list. If it
is, select it by checking it using the Select key. If not, go to the
Frequency Selection menu and the appropriate sub-category
and activate it there by checking it, using the Select key. Make
sure it is “checked” at both menu levels for it to appear in the
current working set of frequencies.
Other Options
The Main Menu also includes options for changing the
display units (feet or meters), adjusting the backlight (on/
off/automatic) and adjusting the contrast setting for the LCD.
Selecting from the Main Menu by pressing the Select key will
display the options or a submenu.