ZyXEL Communications 802.11g Wireless ADSL2+ 4-port VoIP IAD P-2602HWNLI - Manual (Page 94)

P-2602HWNLI User’s Guide
94 Chapter 6 WAN Setup
Password (PPPoA and PPPoE encapsulation only) Enter the password associated with the
user name above.
Service Name (PPPoE only) Type the name of your PPPoE service here.
Multiplexing Select the method of multiplexing used by your ISP from the drop-down list.
Choices are VC or LLC.
Virtual Circuit ID VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual
circuit. Refer to the appendix for more information.
VPI The valid range for the VPI is 0 to 255. Enter the VPI assigned to you.
VCI The valid range for the VCI is 32 to 65535 (0 to 31 is reserved for local
management of ATM traffic). Enter the VCI assigned to you.
IP Address This option is available if you select Routing in the Mode field.
Obtain an IP
Address
Automatically
Select Obtain an IP Address Automatically if you have a dynamic IP address.
A dynamic IP address is not fixed; the ISP assigns you a different one each time
you connect to the Internet.
Static IP Address A static IP address is a fixed IP that your ISP gives you. Type your ISP assigned
IP address in the IP Address field below.
Subnet Mask
(ENET ENCAP
encapsulation only)
Enter a subnet mask in dotted decimal notation.
Refer to the appendices to calculate a subnet mask If you are implementing
subnetting.
Gateway IP address
(ENET ENCAP
encapsulation only)
You must specify a gateway IP address (supplied by your ISP) when you select
ENET ENCAP in the Encapsulation field
DNS Server
DNS Servers
Assigned by DHCP
Server
The ZyXEL Device passes a DNS (Domain Name System) server IP address to
the DHCP clients.
First DNS Server
Second DNS Server
Third DNS Server Select Obtained from ISP if your ISP dynamically assigns DNS server
information (and the ZyXEL Device's WAN IP address). Use the drop-down list
box to select a DNS server IP address that the ISP assigns in the field to the
right.
Select UserDefined if you have the IP address of a DNS server. Enter the DNS
server's IP address in the field to the right. If you chose UserDefined, but leave
the IP address set to 0.0.0.0, UserDefined changes to None after you click
Apply. If you set a second choice to UserDefined, and enter the same IP
address, the second UserDefined changes to None after you click Apply.
Select None if you do not want to configure DNS servers. You must have another
DHCP sever on your LAN, or else the computers must have their DNS server
addresses manually configured. If you do not configure a DNS server, you must
know the IP address of a computer in order to access it.
Connection
(PPPoA and PPPoE
encapsulation only)
Nailed-Up
Connection
Select Nailed-Up Connection when you want your connection up all the time.
The ZyXEL Device will try to bring up the connection automatically if it is
disconnected.
Connect on Demand Select Connect on Demand when you don't want the connection up all the time
and specify an idle time-out in the Max Idle Timeout field.
Table 20 Internet Access Setup (continued)
LABEL DESCRIPTION