Figure 28 manually assign a wpa key, Table 14 manually assign a wpa key, Section 3.3.1 on – ZyXEL Communications 802.11g Wireless ADSL2+ 4-port VoIP IAD P-2602HWNLI User Manual
Page 73: Section 3.3.2 on, 1 manually assign a wpa key, 2 manually assign a wep key

P-2602HWNLI User’s Guide
Chapter 3 Internet and Wireless Setup Wizard
73
Note: The wireless stations and ZyXEL Device must use the same SSID, channel ID
and WEP encryption key (if WEP is enabled), WPA-PSK (if WPA-PSK is
enabled) for wireless communication.
4 This screen varies depending on the security mode you selected in the previous screen.
Fill in the field (if available) and click Next.
3.3.1 Manually Assign a WPA key
Choose Manually assign a WPA key in the Wireless LAN setup screen to set up a Pre-
Shared Key.
Figure 28 Manually Assign a WPA key
The following table describes the labels in this screen.
3.3.2 Manually Assign a WEP key
Choose Manually assign a WEP key to setup WEP encryption parameters.
Table 14 Manually Assign a WPA key
LABEL
DESCRIPTION
Pre-Shared
Key
Type from 8 to 63 case-sensitive ASCII characters. You can set up the most secure
wireless connection by configuring WPA in the wireless LAN screens. You need to
configure an authentication server to do this.
Back
Click Back to display the previous screen.
Next
Click Next to proceed to the next screen.
Exit
Click Exit to close the wizard screen without saving.