ZyXEL Communications 802.11g Wireless ADSL2+ 4-port VoIP IAD P-2602HWNLI User Manual
Page 64
P-2602HWNLI User’s Guide
64
Chapter 3 Internet and Wireless Setup Wizard
ISP gave it to you. Leave the defaults in any fields for which you were not given
information.
Figure 18 Internet Access Wizard Setup: ISP Parameters
The following table describes the fields in this screen.
Table 7 Internet Access Wizard Setup: ISP Parameters
LABEL
DESCRIPTION
Mode
From the Mode drop-down list box, select Routing (default) if your ISP allows
multiple computers to share an Internet account. Otherwise select Bridge.
Encapsulation
Select the encapsulation type your ISP uses from the Encapsulation drop-down list
box. Choices vary depending on what you select in the Mode field.
If you select Bridge in the Mode field, select either PPPoA or RFC 1483.
If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET ENCAP or
PPPoE.
Multiplexing
Select the multiplexing method used by your ISP from the Multiplexing drop-down list
box either VC-based or LLC-based.
Virtual Circuit
ID
VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual circuit.
Refer to
VPI
Enter the VPI assigned to you. This field may already be configured.
VCI
Enter the VCI assigned to you. This field may already be configured.
Back
Click Back to go back to the previous screen.