ZyXEL Communications ES-2108 Series - Manual (Page 78)

Chapter 7 Basic Setting
ES-2108 Series User’s Guide
78
7.6 IP Setup
Click Basic Setting > IP Setup to open the following screen. Use this screen to configure the
default gateway device, the default domain name server and add management IP addresses.
7.6.1 Management IP Addresses
The Switch needs an IP address for it to be managed over the network. The factory default IP
address is 192.168.1.1. The subnet mask specifies the network number portion of an IP
address. The factory default subnet mask is 255.255.255.0.
You can configure up to 64 IP addresses which are used to access and manage the Switch from
the ports belonging to the pre-defined VLAN(s).
"
You must configure a VLAN first.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Cancel Click Cancel to reset the fields to your previous configuration.
Table 11 Basic Setting > Switch Setup (continued)
LABEL DESCRIPTION