ZyXEL Communications ES-2108 Series - Manual (Page 148)

Chapter 19 Multicast
ES-2108 Series User’s Guide
148
19.8.1 MVR Configuration Example
The following figure shows a network example where ports 1, 2 and 3 on the Switch belong to
VLAN 1. In addition, port 7 belongs to the multicast group with VID 200 to receive multicast
traffic (the News and Movie channels) from the remote streaming media server, S. Computers
A, B and C in VLAN 1 are able to receive the traffic.
Figure 81 MVR Configuration Example
To configure the MVR settings on the Switch, create a multicast group in the MVR screen and
set the receiver and source ports.
End Address This field displays the ending IP address of the multicast group.
Delete ALL Select Delete All and click Delete to remove all entries from the table.
Delete Select Delete Group and click Delete to remove the selected entry(ies) from the table.
Cancel Select Cancel to clear the check box(es) in the table.
Table 47 Advanced Application > Multicast > Multicast Setting > MVR >Group Configuration
LABEL DESCRIPTION