ZyXEL Communications ES-2108 Series - Manual (Page 139)

Chapter 19 Multicast
ES-2108 Series User’s Guide
139
Figure 74 Advanced Application > Multicast > Multicast Setting
The following table describes the labels in this screen.
Table 43 Advanced Application > Multicast > Multicast Setting
LABEL DESCRIPTION
IGMP Snooping
VLAN Use this settings to configure IGMP Snooping.
Active Select Active to enable IGMP Snooping to forward group multicast traffic only to
ports that are members of that group.
Host Timeout Specify the time (from 1 to 16,711,450) in seconds that elapses before the Switch
removes an IGMP group membership entry if it does not receive report messages
from the port.
Leave Timeout Enter an IGMP leave timeout value (from 1 to 16,711,450) in seconds. This
defines how many seconds the Switch waits for an IGMP report before removing
an IGMP snooping membership entry when an IGMP leave message is received
from a host.
802.1p Priority Select a priority level (0-7) to which the Switch changes the priority in outgoing
IGMP control packets. Otherwise, select No-Change to not replace the priority.
IGMP Filtering Select Active to enable IGMP filtering to control which IGMP groups a subscriber
on a port can join.