ZyXEL Communications ES-2108 Series - Manual (Page 182)

Chapter 23 Static Route
ES-2108 Series User’s Guide
182
Figure 104 IP Application > Static Routing
The following table describes the labels in this screen.
Table 65 IP Application > Static Routing
LABEL DESCRIPTION
Active This field allows you to activate/deactivate this static route.
Name Enter a descriptive name (up to 10 printable characters) for identification purposes.
Destination IP
Address This parameter specifies the IP network address of the final destination. Routing is
always based on network number. If you need to specify a route to a single host, use
a subnet mask of 255.255.255.255 in the subnet mask field to force the network
number to be identical to the host ID.
IP Subnet
Mask Enter the subnet mask for this destination.
Gateway IP
Address Enter the IP address of the gateway. The gateway is an immediate neighbor of your
Switch that will forward the packet to the destination. The gateway must be a router
on the same segment as your Switch.
Metric The metric represents the “cost” of transmission for routing purposes. IP routing uses
hop count as the measurement of cost, with a minimum of 1 for directly connected
networks. Enter a number that approximates the cost for this link. The number need
not be precise, but it must be between 1 and 15. In practice, 2 or 3 is usually a good
number.
Add Click Add to insert a new static route.
Clicking Add saves your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Cancel Click Cancel to reset the above fields to your previous configuration.
Clear Click Clear to set the above fields back to the factory defaults.
Index This field displays the index number of the route. Click a number to edit the static
route entry.
Active This field displays Yes when the static route is activated and NO when it is
deactivated.
Name This field displays the descriptive name for this route. This is for identification purpose
only.