3 fast ethernet sfp slot, 4 mini-gbic slot – ZyXEL Communications ES-2108 Series User Manual
Page 44
Chapter 3 Hardware Overview
ES-2108 Series User’s Guide
44
3.1.3 Fast Ethernet SFP Slot
The ES-2108-F comes with a slot for 100-Base FX, 100-Base LX or 100-Base BX Small
Form-Factor Pluggable (SFP) transceivers. A transceiver is a single unit that houses a
transmitter and a receiver. The Switch does not come with transceivers. You must use
transceivers that comply with the SFP Transceiver MultiSource Agreement (MSA). See the
SFF committee’s INF-8074i specification Rev 1.0 for details.
You can change transceivers while the Switch is operating. You can use different transceivers
to connect to Ethernet switches with different types of fiber-optic connectors.
• Type: SFP connection interface
• Connection speed: 100 Mbps
1
To avoid possible eye injury, do not look into an operating fiber-optic module’s
connectors.
See
and
for transceiver installation and
removal instructions.
3.1.4 Mini-GBIC Slot
This is a slot for mini-GBIC (Gigabit Interface Converter) transceivers. A transceiver is a
single unit that houses a transmitter and a receiver. The Switch does not come with
transceivers. You must use transceivers that comply with the SFP Transceiver MultiSource
Agreement (MSA). See the SFF committee’s INF-8074i specification Rev 1.0 for details.
There is one Gigabit Ethernet and mini-GBIC slot each. The mini-GBIC slot has priority over
the Gigabit port. This means that if the mini-GBIC slot and the corresponding Gigabit port are
connected at the same time, the Gigabit port will be disabled.
You can change transceivers while the Switch is operating. You can use different transceivers
to connect to Ethernet switches with different types of fiber-optic connectors.
• Type: SFP connection interface
• Connection speed: 1 Gigabit per second (Gbps)
1
To avoid possible eye injury, do not look into an operating fiber-optic module’s
connectors.
3.1.4.1 Transceiver Installation
Use the following steps to install a mini GBIC transceiver (SFP module).
1 Insert the transceiver into the slot with the exposed section of PCB board facing down.