ZyXEL Communications ES-2108 Series - Manual (Page 220)

Chapter 27 Access Control
ES-2108 Series User’s Guide
220
Figure 135 Management > Access Control > Remote Management
The following table describes the labels in this screen.
Table 88 Management > Access Control > Remote Management
LABEL DESCRIPTION
Entry This is the client set index number. A “client set” is a group of one or more “trusted
computers” from which an administrator may use a service to manage the Switch.
Active Select this check box to activate this secured client set. Clear the check box if you
wish to temporarily disable the set without deleting it.
Start Address
End Address Configure the IP address range of trusted computers from which you can manage
this Switch.
The Switch checks if the client IP address of a computer requesting a service or
protocol matches the range set here. The Switch immediately disconnects the
session if it does not match.
Telnet/FTP/
HTTP/ICMP/
SNMP/SSH/
HTTPS Select services that may be used for managing the Switch from the specified trusted
computers.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Cancel Click Cancel to begin configuring this screen afresh.