Westell Technologies Westell LiteLine 6110 - Manual (Page 93)

030-300233 Rev. A 93 May 2006
Westell (Models 6000, 6100, 6110) User Guide
13.5 Static NAT
Static NAT allows you to configure your Router to work with special NAT services. When the Router is configured
for Static NAT, any unsolicited packets arriving at the WAN would be forwarded to this device. This feature is used
in cases where the user wants to host a server for a specific application.
To configure you Router for Static NAT, select Configuration > Service Configuration from the main menu. Next,
click the static NAT button in the Service Configuration screen.
IMPORTANT: Single Static IP should be disabled (if it has been enabled previously) before you enable static NAT.
To disable Single Static IP, select Configuration > Single Static IP Configuration from the main menu. Next, click
the disable button, and then click OK in the pop-up screens to allow the Router to be reset. After you disable Single
Static IP, you should reboot your computer to release and renew the IP address, as explained in section 12.7.2,
“Disabling Single Static IP.” Then, return to the static NAT screen by clicking the static NAT button in the Service
Configuration screen.