Westell Technologies Westell LiteLine 6110 - Manual (Page 46)

030-300233 Rev. A 46 May 2006
Westell (Models 6000, 6100, 6110) User Guide
12. CONFIGURATION
12.1 VC Configuration
The following settings will be displayed if you select Configuration > VC Configuration from the main menu.
If you change any settings in this screen, click save filter settings to save the changes.
NOTE: The actual information displayed in this screen may vary, depending on the network connection established.
NOTE: If you experience any problems, please reset your Router via the external hardware reset button or via the
procedure defined in section 14, “Maintenance” in Backup/Restore.
Status Allows you to enable or disable your VC (Virtual Connection)
VPI Displays the VPI (Virtual Path Indicator) value for a particular VC, which is
defined by your Service Provider.
VCI Displays the VCI (Virtual Channel Indicator) value for a particular VC,
which is defined by your Service Provider.
Protocol
NOTE: The configuration
specified by your Service
Provider will determine which
Protocols are available to you. Displays the Protocol for each VC, which is specified by your Service
Provider.
Possible Responses:
PPPoA = Point to Point Protocol over ATM (Asynchronous Transfer Mode)
PPPoE = Point to Point Protocol over Ethernet
Bridge = Bridge Protocol
Classical IPoA = Internet Protocol over ATM (Asynchronous Transfer
Mode). This is an ATM encapsulation of the IP protocol.
Bridge Broadcast Factory Default = CHECKED