Westell Technologies Westell LiteLine 6110 - Manual (Page 60)

030-300233 Rev. A 60 May 2006
Westell (Models 6000, 6100, 6110) User Guide
12.4 DHCP Configuration (Private LAN)
The following settings will be displayed if you select DHCP Configuration from the Configuration menu.
DHCP Server
This setting allows the ADSL router to automatically assign IP addresses to local
devices connected on the LAN. Westell advises setting this to enabled for the private
LAN.
Possible Responses:
Off = DHCP Server is disabled
Private LAN = DHCP addresses will be saved into the Private LAN configuration.
Public LAN = DHCP addresses will be saved into the Public LAN configuration.
This option is only available if the Public LAN DHCP server is enabled.
Note: These addresses will be overwritten if the Internet Service Provider supports
dynamic setting of these values.
DHCP Start Address Factory Default = 192.168.1.15
This field displays the first IP address that the DHCP server will provide. The DHCP
Start Address must be within the IP address and lower than the DHCP End Address.
You may use any number from 0 to 254 in this address.
DHCP End Address Factory Default = 192.168.1.47
This field displays the last IP address that the DHCP server will provide. The DHCP
End Address must be within the IP address and higher than the DHCP Start Address.
You may use any number from 0 to 254 in this address.
DHCP Lease Time Factory Default = 01:00:00:00
Displays the amount of time the provided addresses will be valid, after which the
DHCP client will usually re-submit a request.
NOTE: This value must be greater than 10 seconds. Seconds must be between 0 and
59, minutes must be between 0 and 59, and hours must be between 0 and 23.
The actual information displayed in this screen may vary.