Westell Technologies Westell LiteLine 6110 - Manual (Page 106)

030-300233 Rev. A 106 May 2006
Westell (Models 6000, 6100, 6110) User Guide
15. TROUBLESHOOTING
15.1 System Self Tests
The following settings will be displayed if you select Troubleshooting > System Self Tests from the main menu.
Click on test all to run a diagnostic test on your Router’s connection.
• To run a DNS test, type the appropriate host name in the field provided, and then click test.
• To run a PING test, type the appropriate IP address or host name in the field provided, and then click test.
• To run a Trace Route, type the appropriate IP address or host name in the field provided and click trace.
• To run a full diagnostic test, click test All.
If you want to PING using the System Self Test screen (diagnostics page) shown above, enter your DNS or IP
address in the fields provided and click the test button. The System Self Test will run a diagnostic test that executes
independent of firewall security settings. See the following table for test descriptions and possible responses.
If you want to PING using the MS-DOS (shell) window, first you will need to check your firewall security setting.
(If you PING via DOS shell you are susceptible to firewall rules, as this PING is dependent on your Router's
firewall settings.) If your firewall is set to Medium or High, you will not be able to PING. You must set your
firewall security setting to Low or None to run a PING test.