Westell Technologies Westell LiteLine 6110 - Manual (Page 82)

030-300233 Rev. A 82 May 2006
Westell (Models 6000, 6100, 6110) User Guide
If you clicked on OK in the preceding pop-up screen, the Host Device screen will be displayed. The Host Device
screen will allow you to select which device will host the NAT service you selected on your local area network. You
must either select the device from the Host Device drop-down menu or type an IP address in the field labeled IP
Address. Click on done.
NOTE: You can attach multiple NAT services to your profile. However, for each NAT service that you attach to
your profile, you must first select the new NAT service. Then, you must load the new NAT Configuration, as
explained earlier in this section.
After you have selected a NAT service and you have saved it to your NAT service profile, the following screen will
be displayed. It shows which NAT service is active for the selected profile. Click details to display the details of the
selected NAT service. If you want to remove a NAT service from your NAT Service profile, click delete button
adjacent to the NAT service.