Oki B8300 - Manual (Page 86)

Saddle stitch finisher — 85
Misfeed in the saddle stitch finisher
When a misfeed occurs in the saddle stitch
finisher, remove the misfed paper following the
procedure below.
1. Unlatch the saddle stitch finisher and
slide it away from the printer.
2. Remove the misfed paper from the main
unit. After removing the misfed paper,
open and close the duplex module to
reset the jam indicator..
3. If misfed paper is not found in step 1,
open the top cover.
4. While pulling and turning roller rotating
knob B, remove the misfed paper. If the
misfed paper is released by turning roller
rotating knob B, remove it taking care not
to tear the paper.
5. Close the front cover.
6. If saddle stitch was selected, open the
front cover.
7. Remove the misfed paper from the stapler
compiler. Be careful not to tear the misfed
paper during removal.
8. Open the saddle stitch section cover.
9. Remove the misfed paper.Be careful not
to tear the misfed paper during removal.